The MDR02 is designed to be used during travel, when small size and a wide A/C-voltage range are important. Line voltages from 100V to 240V can be used to recharge your eneloop. To save on weight and size it´s capability is limited to two batteries only, however as time is often short while travelling the speed of charging has been increased. Two batteries can be charged in less than four hours. The charger comes with a detachable A/C-power cable with either a Euro-plug or UK-plug. The MDR02 can charge either one or two batteries of size AA or AAA at once.
Operating Instructions
1 - Insert the batteries. Make sure to align the + and - terminals of the batteries with those of the charger.
2 - Connect the AC power cord connector to the charger and insert the plug into an electrical socket.
Check if the charge indication light is lit.
3 - The charge indicator lamp will turn off when charging is complete.
The lamp will turn off when batteries are completely charged.if charging is still incomplete after 6 hours of charging, stop charging.
4 - After charging is done, unplug the AC power cord from the outlet and remove the batteries.
Please do not pull out and reinsert the batteries when charge indicatiion light is on. The reinserted battery may not charge properly.
| Charger: | |
Input:
| 100-240V AC, 50-60Hz
|
Output:
| 1,2V, 550mA × 2 (AA)
1,2V, 380mA × 2 (AAA) |
Charge Control:
| Delta V |
Charging Time:
| - 230 minutes ( AA )
- 135 minutes ( AAA ) |
Charge-Indicator:
| LED
|
Size:
| 74 × 71 × 30 mm
|
Weight:
| ca. 78g
|